USED AUTOMATIC/MANUAL TRANSMISSION
LIMITED WARRANTY & INSTALLATION PROCEDURES
PLEASE READ BEFORE INSTALLATION
Prior to installation of your recycled used transmission, we suggest that you perform the following pre-installation maintenance. By performing the pre-installation maintenance you will prolong the life of your recycled transmission and protect your warranty.
Used transmissions comes with a 30 day warranty and is valid under normal driving conditions.
PRE-INSTALLATION MAINTENANCE-AUTOMATIC
REPLACE FRONT SEALS
REPLACE AXLE SEALS
INSTALL NEW TRANSMISSION FILTER KIT
FLUSH & INSPECT TRANSMISSION COOLING LINES
ADD FLUID LEVELS TO MANUFACTURERS SUGGESTED LEVELS
PROPERLY ALIGN & INTALL TORQUE CONVERTER
ADJUST THROTTLE POSITION SENSOR CABLE
PRE-INSTALLATION MAINTENANCE-MANUAL
REPLACE CLUTCH
REPLACE THROW OUT BEARING
REPLACE PILOT BEARING
REPLACE AXLE OR DRIVE SHAFT SEAL
DRAIN GEAR LUBES (IF NOT PREVIOUSLY DONE) AND FILL TO MANUFACTURERS SPECIFICATIONS
INSPECT & ADJUST OR REPLACE SHIFTER LINKAGES
INSEPCT AND REPLACE, IF NEEDED, TRANSMISSION AND ENGINE MOUNTS
NOTE: When interchanging between years and models it may be necessary to change wiring, linkages, and speedometer gears/sensors.
COMPARE BEFORE INSTALLATION! |