Bread Crumb Link

Bill's Auto Parts Recycler

Black Lake Auto Wrecking

Store search

Store categories

Store pages

  • Engine Pre-Instal​l
Shipping & Payment
Parts will be packaged and shipped within 3 business days of received payment depending on item size and shipping method.
Store newsletter!
Add my Store to your Favorites and receive my email newsletters about new items and special promotions!
General Interest
  
USED ENGINE
LIMITED WARRANTY & INSTALLATION PROCEDURES

PLEASE READ BEFORE INSTALLATION

All used engines are sold as long-block engine assemblies; a long-block is defined as:
Cylinder heads, engine block and all internal components. All bolt on accessories left on the long-block engine are not covered by warranty unless otherwise stated on the sales order and are left on the long-block engine to be used at customers discretion. Some engines sold will require you to use parts off your old engine, these change over parts will sometimes cost you additional labor to be switched, Black Lake Auto Inc. is not responsible for the labor cost to have the change over parts switched.

PRE-INSTALLATION INSEPCTION:
1. Inspect engine prior to delivery driver leaving (if applicable), if any damage is found please inform driver and note the delivery ticket and notify Black Lake Auto Inc. If engine is severally damaged, immediately notify Black Lake Auto Inc.

2. Identify that correct long-block engine assembly was shipped to you (if applicable); look at both at both engines to do this. If it looks like the long-block engine assemblies are different notify Black Lake Auto Inc.

3. After removing your old engine, place it next to the replacement engine and identify which parts need to be changed over.

4. Inspect timing components on engine, if miles are over factory specification for a timing belt or chain, replace timing components.

5. Inspect all gaskets for bolt on accessories and replace any gaskets that look brittle or are leaking.

6. Change over any bolt on accessories needed off your old engine.

7. Do not install engine with damaged parts on it, such as oil pan, timing cover, engine mounts, valve covers or manifolds. If engine is installed with damaged parts and they cause the engine to fail prematurely the Warranty Is Void.

INSTALLATION INSTRUCTIONS:
1. Flush cooling system prior to installing engine to remove any debris left over from previous engine.

2. Clean or replace oil strainer and pick screen.

3. Replace oil pan gasket & rear main seal. 4. Drain & replace engine oils to manufacturers suggested levels.

5. Replace oil filter.

6. Timing belts, water pump, thermostat, spark plugs, fluids, and seals are routine maintenance items and should be replaced at the time of installation and at the vehicle manufacturer's recommended service intervals.

7. Replace any water hoses or vacuum lines that need replacing.

8. Prior to starting engine prime oil system and check to be sure you have oil pressure.

9. Proper operation of the cooling and electrical system must be checked during the installation of products that can be affected by those systems.

10. Replace valve cover gasket as needed.

11. Install new belts and hoses.